types

type Config struct {
	// This field must be set to a valid secp256k1 private key.
	PrivateKey *secp256k1.PrivateKey `toml:"-"`

	// MaxPeers is the maximum number of peers that can be
	// connected. It must be greater than zero.
	MaxPeers int

	// MaxPendingPeers is the maximum number of peers that can be pending in the
	// handshake phase, counted separately for inbound and outbound connections.
	// Zero defaults to preset values.
	MaxPendingPeers int `toml:",omitempty"`

	// DialRatio controls the ratio of inbound to dialed connections.
	// Example: a DialRatio of 2 allows 1/2 of connections to be dialed.
	// Setting DialRatio to zero defaults it to 3.
	DialRatio int `toml:",omitempty"`

	// NoDiscovery can be used to disable the peer discovery mechanism.
	// Disabling is useful for protocol debugging (manual topology).
	NoDiscovery bool

	// DiscoveryV5 specifies whether the new topic-discovery based V5 discovery
	// protocol should be started or not.
	DiscoveryV5 bool `toml:",omitempty"`

	// Name sets the node name of this server.
	// Use common.MakeName to create a name that follows existing conventions.
	Name string `toml:"-"`

	// BootstrapNodes are used to establish connectivity
	// with the rest of the network.
	BootstrapNodes []*enode.Node

	// BootstrapNodesV5 are used to establish connectivity
	// with the rest of the network using the V5 discovery
	// protocol.
	BootstrapNodesV5 []*discv5.Node `toml:",omitempty"`

	// Static nodes are used as pre-configured connections which are always
	// maintained and re-connected on disconnects.
	StaticNodes []*enode.Node

	// Trusted nodes are used as pre-configured connections which are always
	// allowed to connect, even above the peer limit.
	TrustedNodes []*enode.Node

	// Connectivity can be restricted to certain Node networks.
	// If this option is set to a non-nil value, only hosts which match one of the
	// Node networks contained in the list are considered.
	NetRestrict *netutil.Netlist `toml:",omitempty"`

	// NodeDatabase is the path to the database containing the previously seen
	// live nodes in the network.
	NodeDatabase string `toml:",omitempty"`

	// If ListenAddr is set to a non-nil address, the server
	// will listen for incoming connections.
	//
	// If the port is zero, the operating system will pick a port. The
	// ListenAddr field will be updated with the actual address when
	// the server is started.
	ListenAddr string

	// If set to a non-nil value, the given NAT port mapper
	// is used to make the listening port available to the
	// Internet.
	NAT nat.Interface `toml:",omitempty"`

	// If NoDial is true, the server will not dial any peers.
	NoDial bool `toml:",omitempty"`

	// If EnableMsgEvents is set then the server will emit PeerEvents
	// whenever a message is sent to or received from a peer
	EnableMsgEvents bool

	// Logger is a custom logger to use with the p2p.Server.
	Logger *logrus.Logger `toml:",omitempty"`
}

type P2pConfig struct {
	p2p.Config
	DataDir string `json:",omitempty"`
}